1. BRICK ROAD CLEANING:
- Use specialized tools to clean impurities, dirt, grease... in the grout, the width of the grout should be 2mm, the depth 3mm-5mm.
2. PREPARATION OF TUBE:
- Install a dedicated plastic nozzle on the end of the glue pipe. Insert the glue tube into the gun, should be pumped evenly, slowly with the speed of moving the glue gun to an angle of 40-45 degrees.
3. SUPPLY INTO RON:
- Remove the first glue when injecting from the glue tube (about 30 cm), to avoid the initial glue mixture is uneven. Then use both hands to hold the gun, apply the glue evenly to the grout of the brick.
4. ROUND SHOOTING:
- Choose iron balls according to the ratio of the brick grout to fit and best fit. Roll the iron ball along the tile grout line with glue, so that it is even.
5. REMOVE SUPPLEMENTARY Glue:
- After 4 hours in the summer and after 8 hours in the winter, when the glue has dried, use a specialized trowel to remove excess glue and clean the tile floor.
6. CLEANING FINISHING:
- Wipe the grout clean with a clean cloth.
Note: When constructing, you should do each finishing area in turn, to ensure the best quality.
Bình luận